Cardo Systems SCALA RIDER TEAMSET Podręcznik Użytkownika Pobierz pdf (Strona 5)

English

3. Search for Bluetooth devices on your phone by following the

phone’s instructions. Please consult your phone’s User Manual

for more information.

4. After a few seconds the phone will list the scala-rider

TeamSet as a discovered device. Select it and follow your

phone’s instructions to accept the pairing.

5. When prompted enter 0000 (four zeros) as your PIN or passkey.

6. Your phone will conrm that pairing has succeeded and the

headset will begin ashing slowly in Blue.

NOTE: If the Pairing process is not completed within two minutes the

headset will return to Standby mode.

With some mobile phones, you may need to tap the CTRL button

to connect the headset to the phone after pairing is complete. The

scala rider TeamSet headset will automatically connect to the last

phone connected to the headset.

SET UP FOR BLUETOOTH GPS DEVICE

If you have a Bluetooth enabled GPS device and would

like to transmit navigation instructions and sounds

from the GPS device through the headset’s speakers,

please follow instructions described in section below

“TO PAIR THE scala rider TeamSet TO A Bluetooth GPS DEVICE”

If you want to use your mobile phone and your GPS device with the

scala rider TeamSet Driver’s unit headset, you should proceed as

follows:

1. Pair your GPS device to your mobile phone (Please consult your GPS

device’s User Manual for more information).

2. Pair your headset to the GPS device as described below.

NOTE: Not all Bluetooth enabled GPS devices allow connections to

Bluetooth headsets like the scala rider TeamSet. Please consult your

GPS device’s User Manual for more information.

TO PAIR THE SCALA RIDER TEAMSET TO A BLUETOOTH GPS

DEVICE:

1. Turn on your GPS device.

2. With the Driver’s unit headset turned OFF, press and hold

the CTRL Button until the Red and Blue Lights begin rapidly

alternating.

3. Search for Bluetooth headsets on your GPS device by following

the device’s instructions. Please consult your GPS device’s User

Manual for more information.

4. If your GPS device prompts for a PIN or Passkey enter 0000

(four zeros).

5. Your GPS device will conrm that pairing has succeeded. The

headset will begin ashing slowly in Blue.

6. If you wish to use a Bluetooth mobile phone to make and

receive calls through the headset, you must now pair your

mobile phone to your GPS device by following your GPS and/

or mobile phone’s instructions.

NOTE: If the Pairing process is not completed within two

minutes the headset will return to Standby mode.

PAIRING BETWEEN THE PASSENGER

AND DRIVER HEADSETS

The two headset units (Driver and Passenger units) are supplied facto-

ry paired. Therefore, you do not need to pair these devices. However,

if re-pairing is needed you may proceed as follows:

1. Make sure that both units are turned ON and close to each other.

2. Press the Intercom Buttons of both devices simultaneously for at least

10 seconds, the red Status Light of the passenger unit will light steadily.

3. If successful, the blue Status Light of the passenger unit will ash.

4. If pairing has failed, the red Status Light of the passenger unit will

turn o and you must repeat the procedure.

scala rider

TeamSet

™

1 2 3 4 5 6 7 8 9 10 11 12

Komentarze do niniejszej Instrukcji

Brak uwag

Cardo Systems SCALA RIDER TEAMSET Podręcznik Użytkownika Strona 5

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Słuchawki Cardo Systems SCALA RIDER TEAMSET